Accessories and Finishing Options
Explore Our Accessories and Finishing Options
Hartson-Kennedy specializes in crafting fully customized countertops, tailored to your specific requirements. Whether you’re renovating a historic residence or designing a bustling commercial space, we’ve got the solution for you. Explore our diverse selection of finishing touches, including sink cutouts and window notches, to discover the perfect fit for your space.
180° Radius
A true 180° (double) radius works best on a Dura-Top (self-edge).
22 ½” Miter
A 22 ½” cut on the matching ends of two countertops that, when assembled, will create a 45° corner turn. This will ...
45° Corner Pie
45° corner without shelf, or diagonal pie cut corner, is a triangular corner insert used when the kitchen design ...
45° Corner with Shelf
A triangular corner with shelf used when the kitchen design would be complemented by a shelf in the corner. State ...
Angled End Base
The countertop is cut to fit 24” x 24” x 24” angled base cabinets.
Banjo
(Square-Edge only) – This is a special notch cut for vanities which provides a ledge over the toilet.
Bump Out
A 3” bump out applied to the front of a countertop is used when a center cabinet is deeper than the two cabinets ...
Butt Joint
A front-to-back seam required for any top over 144” long where two straight pieces of countertop are joined. ...
Clip Corner
A diagonal cut to the corner of a top, which can be done on all styles of countertops. Minimum is a 2” face clip.
Clip Radius
The rounding of the corner of a countertop. Clip radius corners can be done on all styles of countertops except ...
Cutout
The actual cutout placement in the top is given by measuring from the right or the left end of the top to the ...
Dog Leg Miter
A special custom cut miter to extend the backsplash to the edge of a bar top or to miter two tops of different ...
End Cap
A piece of laminate used to finish off or cap the exposed end of the countertop. The end cap is made of one ...
Notch
A notch is a cut into a countertop to allow it to fit around a wall or similar object. Be sure to show exact ...
Single Notch with Backsplash
A cut into the backsplash of a countertop to allow the countertop to fit around a wall or similar object.
Single Radius
The single radius is most common on a flat-deck or bar top. On the Dura-Top (self-edge), the edging flows from the ...
Solid Build-Up
¾” particleboard applied to the bottom side of a substrate that is faced with high pressure decorative laminate. ...
Standard Miter
(90° corner turn) – A standard miter cut is a 45°cut on one section—the “leg”—of a L-shaped or U-shaped ...
Sweep Radius
A soft sweep to the end of a bar top. The arc is 3” on 26” bars and 6” on 36” bars.
Window Notch
A window notch is a cut into the backsplash of a countertop to allow the countertop to fit under a window. Please ...
Y-Miter
A “Y” miter is the result of adding an extension piece up to 22” long onto a countertop to make it longer than ...